In the summer, many installations operate under more pressure than the rest of the year. The rise in ambient temperature affects control cabinets, power supplies, inverters, PLC controllers, and industrial networks. If a plant runs without prior preparation, the risk of alarms, downtime, and shortened component lifespan increases. That’s why, before the hot season, it’s worth checking not just the cooling devices themselves, but the entire automation system.
Start with the areas most at risk
Not every part of the facility heats up the same way. The biggest problems usually show up where control cabinets are placed close to machines, furnaces, high-load lines, or in halls with limited air exchange. Enclosures placed near sunlit walls or in areas with no circulation also cause trouble.
At the beginning, it is good to pick out:
- Control cabinets operating 24/7
- Switchboards with a large number of power devices
- Areas with limited ventilation
- Places where temperature alarms have occured before
Such a review helps to set priorities faster and not get distracted by less important sections of the installation.
Check the actual working conditions in the cabinets
The manufacturer’s declaration for a device is one thing, but the daily operation of the plant is another. In summer, the temperature inside the control cabinet can be much higher than the temperature in the hall. That’s why it’s worth measuring the conditions inside the enclosures before the season and comparing them with the permissible operating range of the equipment.
It’s not just about a momentary reading. It’s better to check how the temperature changes throughout the day, during peak production, and after a few hours of work. This way, it’s easier to spot places where the safety buffer is already very small.
Clean the cooling system and get rid of minor neglects
Many malfunctions don’t start with a major breakdown. Often the problem comes from dirty filters, blocked airflow, or a condenser covered in dust. If the cooling system is working less efficiently than it should, a rise in ambient temperature will quickly reveal the issue.
Before summer, it is worth:
- Clean the filters and ventilation grilles
- Check the condition of the fans
- Remove dust from inside the cabinets
- Access the tightness of the doors and the condition of the seals
- Check the condensate drainage
These are simple actions, but it is often that they decide whether the installation will get through the summer smoothly.
Check if the current cooling is still enough
The equipment in the facility can change every month. New inverters, power supplies, switches, and controllers keep coming in. Each of these devices gives off heat. So it happens that a cabinet that worked fine two years ago now already has too much thermal load.
If you see the temperature steadily approaching the allowable limit, don’t wait for the first shutdown. In such a situation, it’s worth considering changing the cooling method, adjusting the equipment layout, or adding temperature monitoring with alarms.
Prepare a response plan before the heat arrives
A well-prepared plant doesn’t operate on improvisation. When a heatwave hits, the team should know what to check, who’s responsible for reacting, and when to shut down the equipment before a serious failure occurs.
Such a plan doesn’t have to be elaborate. The important thing is that it includes alarm thresholds, a list of critical points, and quick service actions. That way, you don’t waste time when the temperature actually starts to threaten production.
Summer temperature increases don’t have to mean automation problems. If you check the working conditions, cooling status, and cabinet load beforehand, it’s easier to keep production running and avoid costly downtime.
